Cassette or Midstream
Ovulation Prediction Tests
  • When to Test
  • How to Take Test
  • How the Test Works
  • How to Interpret Results
  • Ovulation - The Key!
  • Questions & Answers
  • Help from Momma Kath
  • International Customers
  • Kudos - Satisfied Customers

    • The Ovulation Predictor Kit
    is designed to detect the increase of LH
    and thus predict the time you are most able to conceive.

  • Do not use after Expiration Date.
  • Store in a dry place at room temperature.
  • For In Vitro use only.
  • Keep out of reach of children.
  • Do not open foil pouch until ready to start the test

    HOW THE TEST WORKS
    The Ovulation Predictor Kit is a test for detecting an
    increase of luteinizing hormone (LH) in your urine.
    Normally, about 1 or 2 days before
    the middle of each menstrual cycle,
    the level of this hormone will increase suddenly
    (this is called the LH surge).
    Usually, an egg is released from the ovary
    24 to 36 hours after the LH surge
    (this process is known as ovulation).
    The released egg can only be fertilized
    during the next 24 hours.
    In order to maximize the chance of becoming pregnant,
    it is recommended that intercourse take place within 2 days
    after you detect your LH surge.

    WHEN TO START TESTING
    To find out when to begin testing,
    determine the length of your normal cycle.
    This is the number of days from the first day of menstrual bleeding
    (which is considered Cycle Day 1 "CD 1")
    to the day before the bleeding begins again.
    Take the first day of bleeding as Day 1 and mark it on the calendar.
    Use the following chart to determine when you should start testing.
     
    Total Length of
    Cycle (Days)
    Begin Testing
    on Cycle Day
    21
    6
    22
    7
    23
    8
    24
    9
    25
    10
    26
    11
    27
    12
    28
    13
    29
    14
    30
    15
    31
    16
    32
    17
    33
    18
    34
    19
    35
    20
    36
    21
    37
    22
    38
    23
    39
    24
    40
    25

    Note: If your menstrual cycle is typically
    longer than 35 days or shorter than 21 days,
    you should consult your physician for the recommended day to start testing,
    or ask Momma Kath click to send E-mail

    You may test at any time of the day at your convenience,
    however, late afternoon seems to be the most popular time.
    You should test at approximately the same time each day.
    Do not consume an excess amount of liquid for at
    least 4 hours prior to performing the test,
    to avoid the dilution of LH in your urine.

    HOW TO PERFORM THE TEST

  • 1. Test in the late afternoon after not drinking excess liquids
    and holding your urine as long as possible
    before testing to insure potency of specimen.
  • 2. Collect urine using a clean, dry container.
    If the test will be carried out after more than 1 hour
    from the time of urine collection, the urine should be refrigerated.
    If refrigerated, urine should be allowed
    to warm to room temperature before testing.
  • 3. When your are ready to begin the test,
    open one of the foil pouches
    (open one at a time, immediately before testing).
    Remove the test device from the foil.
  • 4. Draw urine up to the marked on the pipette provided
    (approximately 5 drops).
    Dispense entire content of the pipette into the sample well.
    Wait 3 minutes for the result to develop.
  • 5. Read results between 3 -5 minutes.

    INTERPRETATION OF RESULTS

  • 1. If there is no line in the test region (T),
    or the line is lighter than the one in the control region (C),
    then you have not begun your LH surge and you should continue to test daily.
  • 2. If the color of the line in the test region is equivalent
    to or more intense than the line in the control region,
    you have detected your LH surge. Ovulation should occur within 24 to 36 hours.

    NOTE: All tests are independent of each other.
    It is not recommended to compare readings as the results can change in time.

    QUESTIONS AND ANSWERS

  • Q: Is timing critical in getting an accurate result?
    A: Yes, a timer is suggested to monitor the observation time.
    The color intensity of both the test and the control bands increases over time.
    The rate of increase may different between the two bands.
    Thus the test should be read within the specified time (3-5 minutes).
  • Q: Do I continue testing after the LH surge is detected?
    A: No, you can stop testing when you detect your LH surge
    and save the remaining tests for next month, if necessary :o} .
  • Q: What if neither the test band nor the reference band appears in the window?
    A: Make sure enough urine (5 drops) is applied to the sample well.
    If you do not see that the urine has migrated up the membrane through the window,
    the test is void.
  • Q: What could interfere with my test result?
    A: If you are pregnant, have recently been pregnant or have reached menopause,
    you may get a misleading result. This may also be true if you are taking drugs
    or receiving injections, which contain hCG or LH.
  • Q: What if the LH surge is not detected?
    A: If the LH surge is not detected after 5 days of testing,
    you may have miscalculated your test start day.
    Continue testing with the same brand of Ovulation Predictor Kit
    (do not switch brands).
    If you LH surge is not detected, consult your physician.

    If I can help you interpret results
    contact Momma Kath via email.

    Eggly Thoughts!
    Momma Kath

    Shop for Ovulation Tests

    + + + + + + + + + + + + + + +

    I am here for you!
    So send any
    questions or comments to:

    Positive thoughts :o}
    Momma Kath
    www.MommaKath.com
    + + + + + + + + + + + + + +


    If I can help you understand
    the test results
    click here to send
    me a message.
    As always, positive eggly thoughts :o}
    Momma Kath